Marble Bound 1 Bag Kit (25kg Marble / 1.88kg UV Resin)
Marble Bound is a fantastic new Vuba Innovation! The MarbleBound kit consists of genuine marble aggregates, bound in a UV stable high quality resin binder. The ratio of UV resin binder to aggregates is an industry leading 7.5%. The kit consists of:
1 x 25kg MarbleBound Stones
1 x 1.88kg UV Stable High Quality Binder
UV Resin Total Kit Size = 26.88kg
The marble within MarbleBound has been recycled from off cuts of genuine marble during the manufacturing process of marble floor tiles and marble worktops. The genuine marble is then crushed, graded, cleaned and bagged ready to be included in your MarbleBound system.
This 1 bag kit is perfectly suited to mixing using simply a drill and paddle.
Where can you use?
The Singular Aggregate Sizes (2-4mm or 4-6mm) are designed for domestic, or light duty foot traffic or other none vehicle traffic. The Blends (1-6mm) are a stronger matrix, and suited to commercial or leisure foot trafficked areas (none vehicle traffic).
Our MarbleBound innovation has been hugely popular so far! Our customers have asked and asked for genuine grey colours, and now you have Marblebound! Check out our video here.
Contractor? Why not request our Contractors Price List by emailing firstname.lastname@example.org, or calling 01482 778897 during office hours. You can view our contractor price list here.
The kit consists of:
1 x 25kg MarbleBound Stones
1 x 1.88kg UV Stable Binder
Total Kit Size = 26.88kg
Installation thickness guidance is as follows:
Domestic Foot Traffic = 15mm (Singular Stones or Blended)
Commercial Foot Traffic = 18mm (1-6mm Blended Stones)
For application on to the Vubagrid system, we would recommend an installation thickness of 18mm minimum.
The application thicknesses are an advised minimum thickness throughout the system, you may require a greater thickness when applying on to undulated surfaces.
The coverage rates at those thickness are:
15mm Thickness = 1m2
18mm Thickness = 0.75m2
The basic instructions for the application of the MarbleBound system are as follows: 1. MarbleBound must be installed on to a solid base. That could be primed concrete, asphalt / Tarmac, Vubagrid or other solid paving (contact us for more information). 2. Mix the UV Stable Resin Binder for 1 to 2 minutes, until fully mixed. 3. Pour the mixed resin into a mixing bucket or drum containing the bag of aggregate. 4. Pour the mixed resin out on to the working area, and set the thickness using a pin rake, a Rozzi sledge (Baby or Daddy) or lats. 5. Once set at the correct thickness (1-2mm above finished thickness), applying using a steel trowel to compact and finish the screed. 6. Allow to cure for 48 hours (temperature dependent).